Tyre Removal
• Make sure your tyre is deflated and the bead is pushed towards the middle of the rim and unseated (on tubeless setups).
• Using the standard lever end, slide lever under the tyre bead.
• Push down hard until bead pops over the rim-edge.
• Slide the lever round until the entire bead is over the rim-edge (this may take two hands).
Tyre Fitting
• With your first bead over the rim-edge and your tube fitted you are ready to use the ‘Easy-Fit’ system.
• Again, make sure your tube is deflated and the fitted bead is pushed towards the middle of the rim and unseated (on tubeless setups)
• With a hand on either side of the wheel, carefully stretch the tyre round, lifting it on, until you get to the final few inches.
• Hold the ProForm Tyre Tool in your right hand and fit the rim groove onto a section of rim where the tyre is fitted.
• Push the tool forwards (clockwise) around the rim until the tyre pops into place.
• If you find the bead is working its way off then use the Clip to pinch the tyre together and in place.